-
Hi there,
Are there any plans to support BLE and WiFi like version 1.4.5 and earlier did? I'm specifically interested in both BL702 and BL808. I see that BL808 is only supported in 2.0, so is there…
-
I could not find much information on what the CKS is but the base address defined in the svd overlaps with UART0 at 0x4000a000. What is the correct base address for this?
-
Hi,
Thank you for your support for Bouffalo MCUs in Arduino IDE
I got this dev kit from AiThinker. I get the Done Uploading message when uploading any sketch, but the board isn't doing anything…
-
I read the closed post regarding uploading and believe this one is different.
I have tried the project on both Windows and Linux and Windows was fine. On Linux I ran into a problem where the DT-BL…
-
How to use PIR interrupt?
Which pins can be used for PIR detection?
Thanks!
-
如题,如何使用ch340 ttl转USB的调试连接Radar-01开发板。
询问淘宝官方人员,让我期待后续教程...
最初的教程是用的安信可的调试ttl转usb,但针脚en、信号写入 这两个ch340没有;
即使外接电源了,en连3v也无法调试,希望可以回答一下信息。
-
I was directed here from the examples repo: https://github.com/sipeed/M0S_BL616_example/issues/13
Can you please provide an example of how to set up the device to be used as a BLE Audio acceptor, f…
-
So far on-clip WiFi is not working, a WiFi dongle on USB OTG could allow application developers to go on without waiting.
USB OTG does not seem working too :(
But it should be less dependent on (n…
-
I've successful checked out (and landed patches in) the PineNut master Bouffalo projects. Unfortunately, checking out this project is broken.
% git clone https://github.com/SmartArduino/Doiting_BL.…
-
https://wiki.sipeed.com/hardware/en/maixzero/sense/start.html#Burn-bin-file