-
I just assembled eleksmaker a3 laser and would like to change it's mana controll board which runs grpl on arduino to grbl_esp32 (grbl upload over wifi, faster mcu, ...)
I tried to look up the docum…
-
Hi,
i'm using a lxc container with debian-buster image running on a proxmox server.
i installed redmine, how it is explained in this installation guide : http://redmine-git-hosting.io/how-to/inst…
-
Hi,
I was previously using an Eleksmaker 2.5w laser and it was working perfectly.
I bought a 15 diode laser and i don't know if I'm doing something wrong with the config but it burns deep on the s…
-
I have a 7W laser and just purchased an EleksMaker SE v3.2 stepper motor controller board. With LaserGRBL I can move the laser along the x and y-axis, but the laser will not turn on.
Are there config…
-
hi, here is the log while trying to connect :
`Changing monitoring state from "Offline" to "Detecting serial port"
Serial port list: [u'/dev/ttyACM0']
Connecting to: /dev/ttyACM0
Changing monitor…
-
Hi.
I've connected my laser to shield&power and it's working only on 100% power after making switch ON on laser. All on foto.
![hellp](https://user-images.githubusercontent.com/65569374/82259775-65…
-
Hi I would like to add support for Laser engraving - I have 0 knowledge on this so I want to build one to understand what are the needs, how it works and of course test ESP3D.
I have 500mA laser bu…
-
**To Reproduce**
_Source URL:_ https://engravinator.com/mk1/BOM_Guide.html
_Target URL:_ http://store.eleksmaker.com/index.php?route=product/product&path=101&product_id=163
-
Hello everyone, do some of you use an EleksMaker Pro (62x62cm) with LaserWeb 4?
I have shifts when I want to make a laser fill) + laser cut, I tried different settings (laser power, speed, etc.) in…
-
Hi folks, not sure if this is a bug, or my mis-use of the software, very much appreciated if anyone has any ideas.
I have recently been experimenting with greyscale output on my Eleksmaker A3 engra…