-
https://twitter.com/arthrowl/status/1245323435422728193
> Could you estimate a unit cost? Might help people rationalise their donation, e.g. "my money will pay for 10 visors, neat"
I don't know …
-
One of our first two orders is for 220 of the [3DVerkstan](https://github.com/DoESLiverpool/covid19/blob/master/visor-designs/3d-printed/3DVerkstan/Visor_frame_EUROPE_80mm_4hole_v1.stl) model.
@mdu…
-
klipper uses standard trapezoid acceleration as far I know. I never seen a firmware with s-curve like acceleration and I think it would work better for printers
Some video from https://www.youtube.co…
-
could you please upload the 3D Model if this STL File?
-
Folks,
We need to create a quick survey for medical personnel so we can get feedback on the face shields.
What do we think of the four following questions? Please make suggestions.
Did the face…
-
By putting a chamfer the top edge of the model, it will come out much better and be easier to print. less touch-up work after the print, nobody likes a sharp edged part. And a Step file would be nice…
-
First off, thank you for making these! On the North American version the pegs are larger (elliptical instead of circular). I'm having to double punch the same hole twice to make it fit which is making…
-
These two points are contradictions:
> This work is free to use and modify as needed for non-profit uses. Non-profit for the purpose of this license means revenues not to exceed recovery of materia…
-
I was SO CLOSE to getting V0.4 out the door, but I found and fixed a couple of high impact bugs, and I'd like to get some verification if possible before finally pulling the trigger. I'd LOVE to hear…
-
I don't know enough about this to make a call, so putting this to the community.
In broad strokes, we will need ways to:
1. Secure & distribute funding
2. Source materials
3. Produce PPE
4.…