-
Hi everybody,
I'm using Home Assistant on a Raspberry pi 4 since 1week, I'm little Noob :D
I have download the installation for Raspberry pi4 (32 recommended) and burn the image on Micro SD Card.
…
-
Hey,
i updated my ESP8266 today with the current Development version but it seems, that the current version only captures only 1 of aprox 20 RF Signals. With earlier versions it was working fine... …
-
**Operating environment/Installation (Hass.io/Docker/pip/etc.):**
hass.io in a Rpi3 but all config to the module is done via serial port
**ESP (ESP32/ESP8266, Board/Sonoff):**
https://espho…
-
**Operating environment/Installation (Hass.io/Docker/pip/etc.):**
Docker
**ESP (ESP32/ESP8266, Board/Sonoff):**
ESP8266 + FS1000A (315Mhz)
**Affected component:**
**Description of p…
-
I'm trying to connect SRX882 with nodeMCU v1.3 and it's not receiving any code. It's working fine with FS1000A and XD RF. Any idea?
-
Hi. Is it possible to have RF transmission between the 2 boards? I am using the 315MHZ FS1000A transmitter on Uno and RF-5V receiver on ESP32. Both compile and upload successfully, but on the serial m…
-
Hi
This is not really an issue, but I find the use of RadioHead a bit of overkill for such a simple protocol, and I'm also concerned that potentially RadioHead adds additional data to the start and…
-
Hallo,
Arduino Nano
RX RXB6
TX FS1000A
2016-10-07 22:01:51-MU;P0=-811;P1=689;P2=-322;P3=195;D=01212123012123012303030123030123030303030303;CP=3;#2016-10-07 22:01:52-MS;P1=722;P2=-279;P3=215;P4=-79…
-
I use an FS1000A from which I removed the original resonater (433.92) with a new one (433.42). I know it still works because the FS1000A was still able to control another device. I then changed REMOTE…
-
Hallo,
- Arduino Nano V 3.2.0-b12 SIGNALduino
- 433Mhz China Sender+Empfänger (FS1000A+RV-5A)
Diesen Handsender:
[http://www.handsender-express.com/handsender+TEDSEN+:+SKX1MD](url)
Dieser Funkempfä…