-
I have an ender 3 v2 and im trying to update my firmware. I searched up how to do it and I believe I did everything properly. Formatted the sd card to FAT32. Checked which version of printer I have (4…
-
### Description
When attempting to use the Live Adjustment for setting the Z Offset after installing JyersUI 2.0.1 on an Ender 3 V2 with a CR Touch installed, adjustments to the Z Offset value are …
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
I have done a board modification on the stock Ender 3 v2 mainboard (4.2.2 with TMC2208 steppe…
-
Is it possible to add a menu in LCD to control LEDs or neopixels. is this possible yet? it has been used with other marlin builds currently.
i am able to use the pixels with the firmware but am not a…
-
### Description
Bed leveling isn't activating at all during prints on the last 1.3.5 firmware. It was working fine on older 1.2.2.
### Steps to Reproduce
1. Do a bed mesh and use I M420 S…
-
###Description
E3V2 not booting after accidentally installing the wrong version. ive tried a few solutions however nothing seems to work. (unless im doing something wrong?)
### Steps to Reprod…
-
Even an hour into the print, there doesn't seem to have been any M73 updates sent to the printer, from what I could tell from watching the terminal. Any idea why that might be? Here's the last 1500 li…
-
### Description
Whenever I dial in the Z-offset and probe the bed, the Z-offset changes quite significantly (over 0.5mm). The temperature of the bed remains constant. I am using a CR-Touch …
-
### Did you test with a precompiled firmware?
Pre-compiled options not available for T66 Thermistor
### Bug Description
MPC Autotune fails out with MINTEMP error.
Selecting preheat for any…
-
### Description
### Steps to Reproduce
1. [During the mesh creation at point 42 of 100 the BLtouch probe retracts fully and pushes nozzle into the bed and starts back correct at poin…