-
Installation process of this Armbian:
- Download the image you like
- Install in the SD Card or eMMC via [BalenaEtcher](https://www.balena.io/etcher)
- Check the size of the system partition, may…
-
Are there plans to implement eddy tap support?
Cartographer3Ds implementation for TAP is open source and documented,
Firmware enabling tap feature (For STM32, not rp2040):
https://github.com/Kli…
-
A correction for the pressure advance calibration section: Klipper has patched TMC2208's incompatibility with its version of pressure advance including in standalone mode: https://github.com/Klipper3d…
-
As per the Klipper changelog (https://github.com/Klipper3d/klipper/blob/master/docs/Config_Changes.md), several options/features have been removed.
"20211102: Several deprecated features have been …
-
Hi
I wanted to try the new usb to can bridge mode (https://www.klipper3d.org/CANBUS.html#usb-to-can-bus-bridge-mode) with my Spider 1.1 (with attached CAN transceiver) but only got USB errors on th…
-
During the START_PRINT macro, we are doing a bed leveling. When that happens, if the total difference is above a key level, something like 0.4 mm, then it should cancel the print and echo why to the c…
-
### What happened
After a fresh RatOS 2.0.2 installation, the RatOS dashboard shows the following message:
_v0.11.0-248-gd725dfd3-dirty_
### What did you expect to happen
Not marked as dirty…
-
Hi,
Klipper is probably 3D printing's most advanced firmware.
It is a two part system where the hard math is done on a real computer, and the real time stuff is done on a microcontroller.
A s…
-
Hi @NARUTOfzr you have the Klipper configuration needed for these boards?
-
Hello
Is there any update for these mods?
There are some kilpper-printers which can print in such modes.