-
I cannot seem to get linux to get through init sequence on my T113-s3 based board.
I'm using:
https://github.com/szemzoa/awboot @ 65c67dde704145faf7da75542b63c0eee4f1ad60
https://github.com/s…
-
I read the fwup.conf's `define(ROOTFS_A_PART_OFFSET, 43008)`,
```
# Let the rootfs have room to grow up to 140 MiB and align it to the nearest 1
# MB boundary
define(ROOTFS_A_PART_OFFSET, 43008)…
-
After using this dtb file, the power LED is dead. Confused me a lot with the device status.
And there's no signal on HDMI output.
-
MMC:
```
[I] AWBoot r6172 starting...
[D] DRAM BOOT DRIVE INFO: V0.24
[D] DRAM CLK = 936 MHz
[D] DRAM Type = 3 (2:DDR2,3:DDR3)
[D] DRAMC read ODT off
[D] ZQ value = 0x31
[D] DDR efuse: 0xa
…
-
Add a USB activity check to delay the launch of nwipe, so that all USB storage devices are detected consistently.
At the moment nwipe launches immediately and often this is before devices on the us…
-
Deploy F' on RISC-V. This can use the Zephyr OS layer
-
I'm guessing that since the kernel got updated, the default scripts which were "hard-coded" to k 5.4 won't work anymore
```
INSTALL /home/munin/Projecs/lichee_project/unf_buildroot/buildroot-2022…
-
After installation, the iwconfig shows no new wlan0. An example of the chip is at https://www.fn-link.com/6223A-SRD-Wi-Fi-Module-pd45576170.html
-
SPI: winbond w25q64jvsiq
Here are the steps tested on MangoPi MQ-R (F133-A)
```
$ ./xfel spinor
Found spi nor flash 'SFDP' with 8388608 bytes
$ ./xfel spinor write 0 ../main.bin
100% [========…
-