-
## Panel description
#### Dimensions (in pixels) : 104x52
#### Scan factor: 1/13
#### Chips on rear side: SM5166, DP5125
- Library version: =1.1.6
- Platform: RP2040 Zero
- MCU board: …
-
The root cause is in a way `generate_hal_matrix.py` parsed `src/modm/platform/clock/stm32/module.lb` while populating `file_cache`.
It looks for `(has_driver|get_driver|get_all_drivers)` regexp to …
-
Board
ESP32 Dev Module
Device Description
ESP32 DEVKIT V1 DOIT
Hardware Configuration
No
Core Version
v3.0.2
IDE Name
Arduino IDE 2.3.2
Operating System
Windows 11
Flash freque…
-
I have multiple WLED driven devices set up. Using LEDFX or Jinx to drive them via E.131 works great.
Recently I made some RGB matrixes, again powered by WLED. I'd ideally like to send text to disp…
-
The `monorail` task on Sidecar (rev A) is failing to start up, with
```
15 monorail 67734488 6 FAULT: panicked at 'Could not initialize chip: BadChipId(4294967295)', task\monorail-ser…
-
Discussion here on matrix: https://matrix.to/#/!LdaNPfUfvefOLewEIM:matrix.org/$RQ5btwvUWV83omJJZk1uAHf3eeFXdajv9vYtcqwFcB0?via=matrix.org&via=tchncs.de&via=envs.net
TLDR: it's probably more useful …
-
The following modes are currently supported by the DP3 solvers: scalar, scalarphase, scalaramplitude, diagonal, diagonalphase, diagonalamplitude, fulljones, tec, tecandphase, rotation and rotation+dia…
-
Hi @phiten,
I just tried your config with a brand new Obegränsad display and a Wemos D1 mini (original controller removed from the panel). Unfortunately all I get are just random pixels jumping all…
-
Hewwo dear pwogwammers >:3
**__Introduction__**
Hello, I've been able to run the precompiled Linux Musl Binary from the Release 0.4.5, but when I tried to start it through systemd I get the follow…
-
I have a 64x64 Hub75 matrix hardwired to an ESP32-Wrover dev board. Most effects seem to work fine, Audiograph, Metaballs, Fireplace, SuperNova and Pnog Clock all work. The some effect appears to run …