-
The parser does it work independently from the interpreter. Hence the parser can be run in an extra thread and constantly pass down its results to an interpreter.
This should have the same effect, …
-
When the following code is run, loom claims it deadlocks. This should not happen since the other thread should become unblocked and exit once the last sender gets dropped in `drop(sender)`
[Example…
-
## Introduction
Currently the priority of a SQE is never taken into account when performing RTIO operations.
On place where I could see priority being useful is the submission queue.
When a new S…
-
Currently, server signals are read only on the client, and cannot be updated other than by the server.
It would be nice to have writable signals from the client.
I assume this would involve a si…
-
In the performance test of MPSC, when simulating 2 and 4 producers respectively, Crossbeam's performance is much better than Java-Disruptor, but when simulating 8 and 16 producers, Crossbeam is worse …
-
```rust
use std::sync::{mpsc, Arc, Mutex};
#[tokio::main]
async fn main() {
let (tx, rx) = mpsc::channel::();
let rx = Arc::new(Mutex::new(rx));
let mut handles = Vec::default();
for …
-
Currently, enum variants defined by `custom_error!` macro do not support attributes.
```rust
custom_error! {pub FooError
IO {source: std::io::Error} = "IO operations failed unexpectedly.",
#[c…
-
Using unbounded channels, try_recv can block indefinitely if the sender is stopped at a particular point. This behavior is also exhibited in the std mpsc and in the issue there (rust-lang/rust#112723)…
-
I have a Raspberry Pi 4 with Debian Bookworm.
I have trunk-recorder working on my HackRF up to 10 MHz sample rate, but if I set it higher, I get the Segmentation fault and these errors in the termina…
-
Consider this example:
```rust
use futures::channel::mpsc;
fn main() {
let (tx, rx) = mpsc::channel(1);
for i in 0..100 {
tx.clone().try_send(i).unwrap();
}
…