-
```
What steps will reproduce the problem?
Install NIDAQ drivers from NI. Run any pylibnydaqmx command.
What is the expected output? What do you see instead?
pylibnidaqmx should include the NIDAQmx.h…
-
I have a function:
```
def func():
daq = NIDAQ('Dev1')
task = Task(daq.ao0, daq.ai0)
task.set_timing(duration='1s', fsamp='1000Hz')
task.run(data) # data is a dict
```
…
-
I'm trying to read from my NI 6363 X Series card in continuous mode. I keep running into issues where the buffer overflows after some time even though I am reading faster than the low sample rate I se…
-
Currently, with the new mesoSPIM that we built, it takes ~30 milliseconds to move between adjacent image frames in Z and F.
```
*** ZStack move stage time: 1.025151014328003
*** ZStack move stage…
-
We've been running into a strange issue where a TTL sync signal delivered to the trigger/sync port on a npx basestation isn't logged correctly when recording with openephys 0.6.4 with the latest versi…
-
### Summary
Our python read signal is looking much noisier than the labchart one, which is applying a filter to remove mains noise. We should at least be trying to do the same! May be other filte…
-
@bruno-f-cruz @jsiegle
Hi Bruno,
I tested the shaders timer. The average delay was reduced, but the jitter was still high as shown below.
Josh and I decided to use a digital output (could fro…
-
## *What* is affected by this bug?
Any confocal scanner implementation that does not use the "canonical" NIcard implementation is affected, and requires some level of hacking to get working. There…
-
**Describe the bug**
When a task is cleared (or generally when a component is closed) and then a new component is added, the source will crash.
**To Reproduce**
Steps to reproduce the behavior:
…
-
The DAQmx [class](https://github.com/pymeasure/pymeasure/blob/8086835d8a211268a26451c28a054770b3907d40/pymeasure/instruments/ni/daqmx.py#L60) is not an Instrument subclass, but a plain `class`.
We sh…