-
Hello,
when I try to flash a NUCLEO-L452RE board with pyOCD i get a
**STLink error (16): AP wait**
When I compile the same mbed blinky project for an STM32L152 pyOCD flashes a NUCLEO-L152RE Boar…
-
I am trying to log the data from STM32F429 board to Qwiic logger through I2C port. Below is settings for I2C in STM32F429
Address Mode: 10Bit
Clock Speed: 400K
Following commands are sent from ST…
-
Requesting support STMicroelectronics NUCLEO-G491RE STM32 Nucleo-64 development board with STM32G474RE MCU.
-https://www.st.com/en/evaluation-tools/nucleo-g474re.html
- https://www.st.com/en/m…
-
**Describe the bug**
Older STM32 nucleo board, C-01, do not work with the default zephyr boards files, this is due to the default using an 8MHz clock provided by the ST-LINK chip, which on the C-01 b…
-
**Describe the set-up**
* The board is NUCLEO-WL55JC1
* STM32 CubeIDE v1.15.1
* STM32 CubeMx v6.10
**Describe the bug (skip if none)**
I am running the Lorawan AT Slave example(although…
-
So far, we have been testing the firmware and the backend software by using a USB cable to connect the Nucleo board's on-board ST-Link debugger/programmer to the USB port on a computer such as the Ras…
-
**Describe the bug**
The sample lora send doesn't succeed to send the message on the nucleo_wl55jc
**To Reproduce**
Steps to reproduce the behavior:
1. Build the sample lora\send for the nucle…
-
Hello.
I want to port the OS to a STM32G0 mcu (Nucleo board), which has the Cortex m0+, can someone tell me which files I need to modify, considering the CPU is already supported.
I will really appr…
-
Hello,
I created a STM32 Nucleo based project based.
```
pio project init --board nucleo_g474re --project-option "framework=zephyr"
```
If I try to run `pio run -t menuconfig` it ends in a …
-
# Description
After flash image to Nucleo F411RE board for many times(>5), it will report that no space left on board, we need to reset the board for next flash.
# Test Code
[HelloWorld.js](https…