-
Thanks for the footprint. Quick question regarding the "new" versus "old", is the only difference the dimension? I think I noticed an extra capacitor on the "old" version. Somewhere I recall readin…
-
Time slider under "Oled On display" changes nothing. No matter which value set there - my display turns off after about 5sec.
-
Hello. I have a K7 printer with an ET4000+ board. I downloaded the firmware into it from the main branch, but its start button did not work. When the start button is pressed, the ignition does not sta…
-
Include full support for the most common I2C OLED Displays
- [x] Code refactor to accommodate OLED displays
- [x] Implement basic skeleton and include needed libraries and fonts
- [x] Design and …
-
### Current Situation
Hey,
I have TTGO Lora 32 V2.1.6 flashed with fsk version of OpenMQTTGateway and Nooelec RTL-SDR both listening at 868.95Mhz but one parsing signal from water meter using Wire…
-
OLED over I2C
-
When running pi_logo.py from the examples I get the device info but the screen show for 5/6 static noise and only showing from the top a part (1/6) of the raspberry pi logo scrolling right to left?
I…
-
Having problems with flashfloppy on the new Goteks
Working with a Camputers Lynx interface which works fine with a SFRC922D Gotek (with the STM32F105) but fails with a SFRKC30.AT2 or the .AT4.35 Go…
-
- [x] 1. deviation between pointing direction and prograde (orbital mode on navball)
- [x] 2. ellipse+major axes to show orbit eccentricity, a vector (line from origin) to show orbit's inclination
- […
-
Hello,
I would like to do something like this (this is not valid code; just to give you an idea):
void setup():
oled.setCursor(0, 0);
oled.println(„Headline“);
void loop():
oled.setCursor(…