-
This is a *hardware* bug but I could not find any repo for the MK4 hardware so I post it here.
### Printer model
MK4 (pre-assembled) with original Prusa enclosure
### Firmware version
6.0.…
-
### Printer model
Prusa XL 2T
### Firmware version
6.1.3+7898
### Upgrades and modifications
Enclosure + Highflow Nozzles
### Printing from...
Prusa Connect and USB-Drive
### Describe the bug
…
-
Using RatOS-v2.1.0-RC2, Prusa MK3S does not generate configuration properly.
It is missing definitions for the display and filament sensor. It also assumes, regardless of having selected no accelerom…
-
Hi,
If I want to send photo to prusa server, esp32 stops responding and reboots. I looks like it get no response from prusa server. Do you have any idea what can be wrong?
When I tried print `clien…
-
### Question
I recently upgraded my Prusa i3mk3s 3d printer to 3.14 firmware and I noticed that the Unload Filament Option Was Missing.
-
This is not necessarily a bug with your retraction tower, but I've exhausted all other explanations I could think of including printer firmware and calibration.
In short, the retraction tower fails…
-
### Printer model
MK4S
### Firmware version
6.1.3
### Upgrades and modifications
MK4>MK4S upgrade
### Printing from...
Prusa Connect
### Describe the bug
When printer firmware>hardware>Nozzle…
-
Hello,
I used to have the prusa link 0.7.1 running on Raspberry pi 2w zero on my Prusa MKS3+ printer. All good I decided to update to 0.8.1 and what I did was to flash the image on the Raspberry li…
-
### Description of the bug
Crash detection was turned off in 5.0.0(?) for mk4, due to input shaping. Then in 5.1.0(??) it was disabled by default for the XL, too, in favor of phase-stepping/VFA miti…
-
### Description of the bug
There is annoucement in Prusa Slicer tab after sending file via Prusa connect button - "Connection failed
Something went wrong" but the file is normally start to print..
…