-
I could be missing it, but at a quick glance, I'm not seeing any support for PPS input. Ideally, there should be support for two configurations:
A) Using SHM from gpsd. You might call this "SHM sup…
-
Most likely, we do not need #671 if I understood the content of that issue.
Replacing a waveform would have been useful if the general sequence unrolling was copying the same pulse multiple times,…
-
### The problem
Hi. I've used the code from the following link: https://esphome.io/components/sensor/pulse_meter.html
I used it with my Orno WE520, but if it's not lost connection to my WiFi I've…
-
I just wanted to express my gratitude for such a fantastic product! It works incredibly well, and I can tell how much care you put into creating it.
However, I encountered an issue with the Pulse a…
-
I don't know why but when playing midis in wasabi under pipewire, there's a lot of crackling.
I only recently switched from pulseaudio to pipewire, this issue wasn't present in pulseaudio and only go…
-
Hi,
My configuration is Bigtree TMC2209.
The datasheet talks about a possibility of pulsing the index pin for each step. But I believe it is set now differently, because I see no output on the scope…
-
Hi,
Several routines that sweep qubit drive pulse duration do not adjust the start of the readout pulse.
- [ ] rabi_length_msr
- [ ] rabi_length
- [ ] t2
- [ ] t2_msr
Example from `rabi_leng…
-
It would be relevant to look into ways to store pulses in a driver during the experiments and reuse them during unrolling routines to avoid uploading too many different waveforms that would make the d…
-
Since Pulser API is changing, there must be some tests to check compliance with `SimConfig` for mitigation purposes.
-
Comment (optional):
Error:
```
Error: Cannot execute Get-AuthenticodeSignature, stderr: Cannot invoke method. Method invocation is supported only on core types in this language mode.
At line:1 c…