-
### Describe the bug
On my JK bms there are 2 temperature sensors. One sits on the battery cells and the other sits on de battery fuse.
In issue #26 the problem is fixed that the wrong sensor showed…
Pim57 updated
2 months ago
-
Hi all, I need help with these error on vedirect.
All was working good until I updated to emonSD-08May21
I’m getting checksum errors, but it doenst happen with older version of emonSD
Any help??
…
-
### Describe the problem
Venus OS shows a Voltage High alarm everyday, I guess caused by the SOC reset feature.
Is this normal behavior or do I have wrong settings applied?
### Driver version
…
-
### Describe the problem
Hello everybody,
since two days I´m testing the dbus-serialbattery driver in use with a SEPLOS V3 BMS. Before that, more than one of a year there was a JK BMS connected an…
-
### Describe the problem
Hello,
I have been running the driver for a long time on a Daly BMS with a 100 Ah battery made of 16 Lifepo4 cells.
I updated the driver to the current version v1.2.2…
-
### Describe the problem
My Multiplus II doesn't go into float mode. (bulk to absorption only).
Serial-Battery shows "Float (linear mode)" in Venus OS under JKBMS => Parameters
As you can see in …
-
### Describe the bug
I noticed that sometimes dbus-serialbattery reports very low or high single cell voltage, affecting SOC calculation and general state of the system.
To diagnose the problem I ma…
-
### Describe the problem
Hallo Zusammen,
Ich habe folgende Umgebung:
Raspi4 mit VenusOS Verion v3.30
2x Seplos Batteriepacks BMS Seplos BMS V16 (10E) Software Version: 16.6
venus-os_dbus-seri…
-
### Describe the problem
I have two FSK 300HP batteries that have the same unique identifier so only one is loading using the latest driver version. The log files says to change it but not sure wher…
-
### Describe the problem
Hey guys, I have a vicctron ees running for more than year now , it was running fine at Venus Os 3.0 and for some strange reason i got the idea to update all the Software …