-
When automatic ACK mode is turned on, **_sendFrame is called from _interruptHandler**. _sendFrame than contains:
`with self._sendLock:`
`....self._setMode(RF69_MODE_TX)`
`....self._sendLock.wait(1.…
-
Investigate possibility of porting RFM69Pi Rx code to D1 to receive directly via an RFM69 attached via the hallard D1 board.
-
I think i might have made a mistake when buying your product as i dont think it will mix with my environment. Im using an SRX822 433mhz receiver that I have setup as my mqtt gateway. I simply need the…
-
Hey there!
To help with my understanding, I am used ot using a network address and selected nodes from there for the sending // receiving. Does this mean that this wouldn't be compatible with your r…
-
Hello, I would love to see the schematic on this please. It would really help me with a project I have trying to incorporate the ATMEGA and the RFM69 please. Thank you!
-
After the previous issue I mentioned (issue 122), I had a good check through the code, as requested, and found a few places where there were 8-bit addresses used, where they should probably be using 1…
-
I copy from my "list of thoughts" :-)
Cheap crystals can have up to 100ppm frequency offset and indeed such offsets are observed with the cheap RTL-SDR USB receivers. This is not a major problem, a…
-
The current RFM69 library used (from lowpowerlabs) does not support the RFM95 LoRa radios. The GW should either move to the rocketlabs library (that supports both) or at least use it to support RFM95 …
-
The following keywords need Doxygen comments and inclusion in keywords.txt
- [ ] MY_NRF5_RX_BUFFER_SIZE
- [ ] MY_OTA_I2C_ADDR
- [ ] MY_RFM69_DEFAULT_LISTEN_IDLE_US (already present in keywords.txt …
-
https://github.com/arduino-libraries/ArduinoLowPower/blob/6fd308af4aaf2759a13697f9e670e427eb517b3a/src/samd/ArduinoLowPower.cpp#L9
The comment at this line says "disable GCLK module". But my readi…