-
Hello there, i was trying to design my own pcb board for brushless motors control based on stm32, and i was wondering if i can use a already made firmware like BLHeli32, but i dont find and cant uplou…
-
```
What steps will reproduce the problem?
1. Plug in a STLink
2. Attempt to use it immediately
3. Hilarity ensues
What is the expected output? What do you see instead?
You expect to be able to use …
-
```
What steps will reproduce the problem?
1. Plug in a STLink
2. Attempt to use it immediately
3. Hilarity ensues
What is the expected output? What do you see instead?
You expect to be able to use …
-
When the title error occurs, the only alternative left for me is to disconnect and then reconnect, and then it works. However, before doing this, I list the probes and it is present.
```
$ telepro…
skhaz updated
4 months ago
-
When I try to upload a program with stlink (Sketch->Upload Using Programmer), it compiles but fails with the error "Error while uploading: missing 'program.params.verbose' configuration parameter".
…
-
$ make flash
make[1]: Entering directory '/home/pi/STM8/blink/stm8builder/flasher'
stlink.c: In function ‘stlink_read_and_cmp’:
stlink.c:62:6: warning: unused variable ‘recv’ [-Wunused-variable]
…
-
I'm trying to program a Nucleo STM32L432KCU6.
I've verified the STLink v2.1 appears properly on OS X:
STM32 STLink:
Product ID: 0x374b
Vendor ID: 0x0483 (STMicroelectronics)
I've also up…
-
```
What steps will reproduce the problem?
1. Plug in a STLink
2. Attempt to use it immediately
3. Hilarity ensues
What is the expected output? What do you see instead?
You expect to be able to use …
-
I'm fairly new to this and recently got myself the [STLINK-V3](https://www.st.com/en/development-tools/stlink-v3set.html) (so far it was a mistake..). I want to install this opensource [PEAK PCAN firm…
-
I'm getting this error:
'''
erwincoumans@Erwins-MBP build % psdb_flash_tool --connect-under-reset --erase
Probing with SWD frequency at 1.000 MHz
Set SWD frequency to 24.000 MHz
Erasing entire …