-
Hello,
First, thanks for this useful work!
I have an issue with the TimerMillis library when I used 2 timers at the same time and restart those timers with different timing. Here a minimal sketc…
-
Hi,
The device id for stm32l0 is pointed at 0x1FF8_0050 in this crate. This doesn't match the l0x0 version, as it is 0x1FF8_0050 + offset 0x14 here.
See page 722 of the reference manual: https://w…
-
What's the exact reason for that? Mentioned at:
Your declaration will not work, because some internal use prevents PIN_ATTR_EXTI on PA0 (so either your interrupt will work, or LoRaWAN, but not both…
-
Dear Thomas,
You have done a great job with this library for the STM32L0 and I was wondering if you have planned to port it to the new [STM32WL](https://www.st.com/en/microcontrollers-microprocesso…
-
When using the following configuration for a 32 MHz system clock, which is possible since #129, a hard fault is generated:
```rust
let mut rcc = dp.RCC.freeze(Config::pll(PLLSource::HSI16, PLLMul::M…
-
There is a serious compatibility problem with ESP series.
When you remove `if (status.newDataFlag) { } else ...` tags from example it's being fixed.
-
While trying to compile the code from an RPI, using arduino-cli, I have encountered the following error:
`Error during build: fork/exec /root/.arduino15/packages/TleraCorp/hardware/stm32l0/0.0.10/…
-
Hi,
I'm using littlefs on a stm32l0, using only static buffers, the issue I found is that when using LTO the look ahead buffer (defined as `uint8_t` array) gets placed in a address that is not 32b…
-
Hi all,
My RFID project is with CLRC663 using stm32l0. So far with the help of the code here I managed to get ATQA, UID, SAK, ATS and also read and write to Mifare classic card, work. However I ca…
-
I am using a custom board with the murata ABZ chip (STM32L0 series), I am sending and receiving successfully at any other time except when the device first starts.
If there is a scheduled downlink…