-
Sir, my Extruder 1 is not working, its connected to E4 port
E0 (connected to E3) and E2 (connected to E5) working well
there is no problem with Driver Or Motor (i checked with swapping with other dr…
-
What is a replacement for this in TMC5160?
and driver.VACTUAL(50000); and driver.SG_VALUE() this two also.
-
I've come across a few cases where you've written code that assumes int is 32 bits and/or two's complement, I think it would be reasonable to use int32_t in most of these cases as it's already used in…
-
A sudden quick print head move (X and Y motors) blew up the U2 (SGM6130) power chip leaving the board not operational...
Is there proper protection from such voltage coming from the motors?
Driver…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
After #25758 (More endstops refactoring) homing doesn't work anymore. When sending G28 …
-
Hello, I got some TMC5160 v1.2, can they be used to replace drv8825?
-
Hello
In my setup I intend to switch the 48V to the TMC5160 drivers on only when needed, so when i boot everything up VMot is 0V. Under these conditions autotune will cause an error and will make …
-
This drivers work in BTT SKR2 and FLY Gemini V1.
I have tried different speeds for SPI clock: from 100000 to 4000000 Hz.
Log from Fluidd Console:
```
12:19:56 // Klipper state: Ready
12:24:39 $…
-
I saw that you're working on an advanced version with a TMC5160 driver, for this version I'd recommend looking into the Broadcom AEAT-9955 encoder, I've had great experiences with it and it also suppo…
-
Hi
My special application needs 4 small nema 17 motors driving 1 central axle
Driver is tmc 5160 3Amps, 24 V
movement is troublesome
I am a bit stumped, 70 watts should be more yhan enough
S…