-
**Describe the set-up**
* stm32h743iit6
* threadx + usbx
* use USB_OTG_HS as CDC host ,
* USB_OTG_HS dma_enable = ENABLE and enable the dcache
* vscode gcc13.2.0
**Additional context*…
-
In the python manual, there is no mention how the monsoon monitor to be connected to the computer and how to verify the connection is correct.
I just connected the USB port from the back of the HV…
-
Hello
I tried to replicate the board with a different mcu (STM32F042K6T6: same but bigger flash) with no success including the USB_DEVICE library using CubeIDE. I get some errors while compiling _us…
-
Given this is a Atmega32u4 chip (Leonardo board) - should I not be able to use the Keyboard library (I'm talking USB HID - NOT BLE)?
Commands such as Keyboard.begin() and Keyboard.println() although …
-
### Board
ESP32-S3-WROOM-1-N16R8
### Device Description
Plain module ESP32-S3-WROOM-1-N16R8 in a custom PCB.
### Hardware Configuration
GPIO 19 and 20 are connected to a host USB (PC or…
-
Hi!
First of all, I would like to congratulate and thank you for your help in developing the CP21x driver library for the Arduino. It was an impeccable job that inspired me to develop a similar libra…
-
At the time libnifalcon was written, it was hard to find a usb/ftdi library that supported our async needs. That's probably changed in the past few years. Would be nice to settle on a single cross pla…
-
I have a project where I have the Pico SDK in a git submodule. I recently tried upgrading the SDK from version 1.5.1 to version 2.0.0, and now I have compilation issues where runtime_init.h isn't foun…
-
From @kempster101
V 2.8.1 library build from USB drive took two boots. Plugged in USB drive after initial boot, Library recognised the audio files and built the library accordingly. However, files co…
-
I tested on multiple bladeRFs and I always get errors on my raspberry pi 5
```
Jul 22 15:20:16 pi sh[54887]: [ERROR @ host/libraries/libbladeRF/src/backend/usb/nios_access.c:68] Failed to send NIOS …