-
I am running a 5161 on an ESP32, I am getting '0 1 292' and the motor is not moving, this is what i have wired
EN_PIN -> 14
MOSI ->MOSI
SCK -> SCK
CS -> SS (i have tryied Salve Select and a non-…
-
Hello,
I tried several examples and different parameters on the examples provided, and none of them allowed me to reach the 1/3 of the motor speed.
At this time, I'm running the driver TMC5161 f…
-
Hello folks.
I am trying to get the "MKS TMC2160-OC V1.0" driver working with my Arduino Uno board & a Nema23 stepper.
I connected all wires from the driver SPI (CS, DO, DI and SCK) to the corresp…
-
Hello there,
currently I am working on a Arduino project, with an arduino and a TMC5160 Stepper Driver.
The goal of this projcet is, to let a Nema 23 Stepper turn in both directions. Easy as that…
-
Checking the documentation, there is none for version 1.2. The motion controller mode also appears selectable via solder pads on version 1.0, but there is no reference as to where those pads are on t…
-
While testing some stepper I noticed that they became rather hot even if the TMC2208 was configured with a conservative rms current using `rms_current(uint16_t mA, float mult)`
Checking current con…
-
hello, this is not an issue but i didn't know where else to ask. I saw you added support for 5160 and i was wondering if the differences are big and weather the code for 2130 could work for at least b…
-
I am currently working on adding support for additional sensors connected to the Qwiic connector of the CO2 Ampel. The focus will be first to support the Sensirion SGP30 sensor to also allow volatile …
-
Hello,
I am trying to make the TMC5160 vom BTT to work.
I am having the v1.2 and 1.3v of these stepper drivers.
Both do not have any solder pads or jumpers to change their used mode (as far as I …
-
Hi everyone, I bought two tmc5160 from bigtreetech more specifically these https://www.biqu.equipment/products/bigtreetech-tmc5160-v1-0-driver-spi-mode-silent-high-precision-stepstick-stepper-motor-dr…
ghost updated
3 years ago