-
-
Thank you for your project. Now I'm using Wemos D1 Mini32 board (& Tindie Opentherm master shield).
It will be great if your gateway could support Ethernet connection instead of wi-fi. It is more r…
-
I want to use the new dht 12 shild 2.0 from Wemos. Sould i use DHT 1 or DHT2? And which Pin?
I have the old (dht11) runnig ok with pin 2 and dht 1...
Greetings cubert
-
Got 2 SHT30 shields. The shown temperature is ~30°C, while the real temperature is ~23°C.
I didn't investigate yet, but the temperature is wrong with both shields, very far away from the real one. Th…
-
Hi,
I try connect relay to Wemos D1 via 5th pin port (opposite the port is written D14/SDA/D4), but nothing happens.
Sample code:
```
void setup() {
pinMode(D4, OUTPUT);
}
void loop()…
-
Hi there,
I'm trying to read outdoor values, but something is wrong, I'm getting wrong readings.
SHT3x readings:
```
Temperature: 3.59c
Humidity: 68.50%
```
But, the real values should be:
…
-
I first tried the sdfat example, then the console_spiffs, as last the db_small example. All of them show the same Error, "file is encrypted or is not a database".
_Monitor output in last db_small:
…
-
Hi,
I'm use DIYLESS master shield. This shield have a temperature sensor connect to pin 14. How I can set it in yaml instead of HA sensor?
thanks
-
Hi,
Arduino IDE : 1.8.1
Wire.h: 1.0.0
I have a few sketch with SHT3x lib than works well for a long time.
But now, when I want to flash a sketch on D1 mini pro, It's not working. With the basi…
-
Hello, I use the shield with wemos d1 r1.
Shield uses pins D2, D3, D4 and D5, which is mapped to gpio 16, 5, 4, 14 according to ![wemos d1 r1 schema](https://aws1.discourse-cdn.com/arduino/origina…