-
When the Data mode is enabled on an Icom 9100, the program does not switch to DIG mode. It remains in SSB mode.
-
First THANK YOU so much for sharing your code and hardware designs. I was trying to build the same kind of radio - a pico controller and audio input and output for ft8, etc. I was able to use the c co…
-
It looks as though CWSL_DIGI submits the timestamp of the *start* of the transmission rather than the *decode* time. This confuses the analyzer that looks for incorrect QRG on the reports -- it assume…
-
Morning Everyone,
For a little while now I've been trying to get my Funkamateur FA-SDR kit controlled directly by CubicSDR from the radio menu, without success I'm afraid.
The FA-SDR kit is inc…
g0oan updated
6 months ago
-
I'm using JTDX v2.2.159, and when I run the JTDX-Helper, I get this error:
Error-x:
JTDX windows is blocked
- Remove blocking and restart the JTDX-Helper
I can't find any setting related to th…
-
Hi Pavel,
i lately built up a WSPR decoder based on your marvelous software on a Red Pitaya 122-16. It does a great job, only one thing i miss is uploading the spots in parallel to pskreporter.info…
dc7ds updated
10 months ago
-
All other bands appear ok, but when changing VFO from say 10386.100.000 to 10386.099.000 on Transceiver, WSJT-X will change from normal 3CM 10,386.100 000 to OOB 386.099.000 dropping the 10.
Pictu…
-
With the headless version now available, all commands previously available via buttons are now remote serial port commands. Additionally CPU reset, Cal table dump, and upload a cal value are added. …
-
I really like the xMini view, especially paired with multiple WSJT-X windows. There are sometimes I don't really care about decoding or displaying the full IQ spectrum.
However, what I'd love to se…
-
Can't setup ft-991a internal board audio