-
I have ESP32 devkit v1 (30 pins)
https://www.aliexpress.com/item/33028843524.html
and display Opensmart 3" R61509V
https://www.aliexpress.com/item/33040167526.html
I did not find pin 17 and 16…
-
I have a D1 mini and plan to use it with MQTT and openHab as the main hardware interface for a house alarm system. The idea is to have the currently installed hard wired PIRs feed their N/C outputs in…
-
Hi, I have a question about your board. If I understood correctly, the power supply for the board itself can be selected up to 24V. LED strips there are but only 5-12V right? The DC-DC converter conve…
-
I'm working with ESP8266 Wemos D1 shield.
IntelliSense detects problem in finding the GPIO keywords
![image](https://user-images.githubusercontent.com/16566804/120322185-6eab8a80-c2e4-11eb-8932-…
-
Hello
I would open an issue, because the actual ESPeasy Mega software does not support AHT10 humidity/temp sensors and I have a few of them and would use them with my standard firmware for ESP8266 ..…
-
Hi everyone,
After going through all threads and tutorials possible, I still can't find a solution to my problem. I try to run TFT_eSPI on ESP32 with 128x160 LCD display with ST7735s driver, but th…
-
Hello,
I am trying to test this version but it is impossible to modify the number of LEDs in the configuration.
Can you take a look at it?
Greetings
-
See https://github.com/letscontrolit/ESPEasyPluginPlayground/pull/176
It should be documented that this sensor cannot (!!!!!) be used along with any other I2C device.
Not tested if it may work alo…
TD-er updated
3 years ago
-
Are there any plans to support or to config even smaller displays?
e.g. I have this display http://www.esp8266learning.com/wemos-oled-shield-example.php
Screen Size: 64×48 pixels
Does not make muc…
-
I've tried everything.
I had it working fine. Pairing was not a big deal, I used a Raspberry Pi to pair it with `bluetoothctl`, then powered it down and used the Pi's BT mac address in my sketch.
…