-
The error message **radius=0 is invalid** is displayed in the Command line box repeatedly when using the Center + Radius tool, and entering a division expression for the radius
### Expected behavio…
-
#### Hello, administrator,
Have you considered using the drawText function in the QPainter class and the QFont class to implement single-line fonts instead of the double-line fonts currently implem…
-
### Expected behavior
That the application would open on Ubuntu 22.04 LTS 64 bit default installation.
### Observed behavior
1. In making the Appimage executable, doouble clicking on the appl…
-
### Expected behavior
To be able to see Librecad in the dock
### Observed behavior
Librecad disappears from dock and the system. Its like its uninstalled or was never even installed
### Steps …
-
### Expected behavior
command is typed in command bar,
the tool is run as enter is pressed
### Observed behavior
Unknown command: xxxx
is displayed
where xxx is
fillet
offset
o
bev…
-
LibreCAD 2.2.1 alpha 359 appimage on Puppylinux Fossapup
With the introduction of pen palette and layer tree the minimum width of the right side dock widgets has expanded from about 246 to 413 pix…
-
Hello @harvie,
a few days before you updated bCNC so that I can start the code with a click on the hardware "start" button.
Today I got some strange problems. I haven't change anything in the so…
-
Creating an Issue to follow up on the discussions on the facebook-page. The current license is very restrictive and makes it impossible to change the code and restricts its usage. In the spirit of man…
stone updated
2 years ago
-
### Expected behavior
Dimension value is shown in the middle of arrow as for this version:
Version: 2.2.0.2
Compiler: GNU GCC 9.4.0
Compiled on: Jul 29 2023
Qt Version: 5.12.9
Boost Version:…
fa201 updated
4 months ago
-
Enter a command shortcut or fullname, hit enter or spacebar, command starts
Enter a command shortcut of full name and response is always "command unknown". Sometimes it works fine and then all of …