-
### Description
Just installed an SKR 1.3 with TMC5160 on my Ender 3 and uploaded Marlin 2.0 and now I get this error everytime I try to turn on the printer "Driver Error: 8 Printer Halted"
I c…
-
Hi all,
Thanks in advance for your great (and probably hard) work.
Here is my issue
### Configuration
Printer still under assembling
SKR v1.3
TMC5160 using SPI on X/Y/E (sensorless homing activa…
Patag updated
4 years ago
-
### Bug Description
Hello!
Last week i have a battle with my TMC5160.
On boards: SKR 1.3(2pcs) and SKR 1.4 Turbo
I got the same problem with TMC5160 1.2 from BTT (X Y Z E Z2)
Version of Marlin …
-
Hi,
I purchased the SKR1.3 and TMC5160 v1.2 from BigTreeTech, i first tried to simply connect the driver to the board but the command M122 returned Testing X connection... Error: All LOW on all ax…
-
### Description
I was originally running genuine Watterott TMC2130 drivers in SPI mode on my Azteeg x5 mini v3 controller board, with the SDO, SCK, and SDI pins for the drivers wired to the SD card…
-
### Bug Description
I've set a specific homing current for my TMC5160 to make the sensorless homing working more reliable. However the set homing current is still used when starting the print, which …
Lyr3x updated
4 years ago
-
Attached is my config.
With an SKR v1.3 and tmc5160's after homing just the X axis to the MIN, I am still able to completely blow by the software end stop.
Tried a great number of things, maybe…
-
Hello everyone,
atm I´am working on a big selfmade Delta-printer for Ceramics.
The setup:
- Skr Pro
- TMC 5160 V1.2 BTT (removed the CLK Pin), SPI
- Nema 23, 3 A, 1,8°
- 24 Volt Power supply
…
-
### Description
Just upgraded to SKR v1.3.
Had a succesful print, but temperature was way unstable. PID tune needed.
After successful PID tune and save to EEP => No movement is possible.
…
-
### Bug Description
Marlin is stuck in bootscreen.
### My Configurations
Hardware:
Printer design: Delta
RUMBA32 (rumba32_f446ve)
REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
TMC5160 x6 …