-
Without graphic LCD support enabled (for instance, for the RepRapDiscount LCD or the VIKI 2.0), Marlin compiles to about 80 kib. With it enabled, it compiles to about 135 kib. This is just slightly to…
-
When attempting to configure Marlin with `EXTRUDERS` > 1 but using a board with only one heater output (in my case `BOARD_RAMPS_13_EFB`), compilation fails with the errors below because it can’t find …
-
When I use the MBL function in Marlin RC8 , the printhead start at 10mm above the printbed , and I must corrected more than -10mm to adjust the levelhight at Z 0.1 mm.
How can I adjust the Z hight …
-
**Application version**
(The version of the application this issue occurs with.)
happened first on 4.6.1 later tried 4.5 and same issue, also tried a totally fresh install of 4.5 (removing all e…
-
Cannot get the Buzzer to chime when sending M300 S1000 P1000.
The buzzer works with the LCD button press, but will not work with M300.
Any ideas?
-
### System information
SolveSpace version: 0a061b6f9ea8ea10414e04a6a87c14c6b12ad04b
Operating system: Windows 7
### Expected behavior
Viewport should be redrawn every mouse move event
###…
-
I've had this start up script for ages. Printer is working fine, both temp sensors are ok.
I flashed 1.1.0-RC10 and now I'm constantly getting a thermal runaway for bed exactly AFTER G29 is complet…
-
Hi , I used your latest Marlin RCbugfix ( Latest commit a545290 6 hours ago) and uploaded it with IDE 1.6.8 , here are the results :
```
I can push the knob on "Prepare" and "Level bed" and then I tu…
-
Using the latest build and when I issue a G28 command to home all axis the autobed leveller servo tries to swing down but crashes into the edge of my bed and will not trigger. The Z axis is still tryi…
-
As more end-users upgrade to 32x micro-stepping with drivers like the DRV8825 we're seeing more issues where innocuous activities like homing the Z axis will cause the CPU to become so overtaxed that …