-
I use sdr-shell -> DttSP -> usbsoftrock to control a softrock RXTX.
Just upgraded to wsjtx-2.0.1 which uses Hamlib 1.4 to communicate with sdr-shell.via the Hamlib NET rigctl device.
Hamlib's ne…
-
I am using Windows 10, RigCtl last version and GPredirect 2.3.37 as decribed here
http://w7hd.ddns.net/yaesu/ft991a/gpredict-ft991a.pdf
Everthing is fine as long as I run GPredirect in the backgro…
-
Hello all,
I am trying to get the new Icom IC-9700 doppler control work but I get erratic control.
I did try to use the IC-910 driver from hamlib-w32-3.3 by changing the CIV adress to my IC-9700…
-
In one of the last few merges the rigctld-WSJTX connection for the IC-7300 appears to be broken. WSJTX does not see a sub VFO and issues Hamlib error: Invalid parameter while exchanging VFOs.
WS…
-
Setting frequency and mode on the FT-991A appears to be broken. Getting frequency and mode are OK. The debug log, below, shows init, f, F and w FA;
--Howard
-----------------------
pi@rigpi4:~…
-
The normal rigctl TX/RX commands (T 1, T 0) work as they should. However, w TX; and w RX; wait for a response from the radio for 2.5 seconds before timing out.
--Howard W6HN
Rig command: w RX…
-
Hi nice team,
would it ever planned that setting CTCSS with rigctl is possible. WIth 3.3 message not supported appears
would be nice for sat op
tnx
73 Alex, OE3JTB
-
This is mainly a question about the protocol implementation: the bug can be either in Hamlib or K3NG firmware.
I'm trying to use K3NG rotator firmware (https://github.com/k3ng/k3ng_rotator_controll…
-
Power on using set_powerstat for the TS-480 appears to be broken. The TS-480 has two power off modes, one (PS3;) where the cpu sleeps and the other (PS0;) where the cpu is active. Shouldn't the TS-…
-
I'm using rigctl 3.3 and I realize the TH-D72a driver is ALPHA but I was doing some testing for an upcoming project things didn't get off to a good start.
I start things off with:
rigctld -m 233 -…