-
Hello :)
I come back with the problems of vage on the axes
see the pictures
I'm clearly not the only one with this problem I have a lot of printer and most are making waves
I confirm that it does …
-
Hello everyone,
atm I´am working on a big selfmade Delta-printer for Ceramics.
The setup:
- Skr Pro
- TMC 5160 V1.2 BTT (removed the CLK Pin), SPI
- Nema 23, 3 A, 1,8°
- 24 Volt Power supply
…
-
### Bug Description
Marlin is stuck in bootscreen.
### My Configurations
Hardware:
Printer design: Delta
RUMBA32 (rumba32_f446ve)
REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
TMC5160 x6 …
-
### Bug Description
Dual Y Configuration.
Y0 Goes wrong direction 50% of the time.
That is no mater what direction you send, it always moves positive.
### My Configurations
[Marlin Con…
-
Im trying to compile this code here: https://github.com/watterott/SilentStepStick/blob/6177f3cd0812d963b8c77c646558010d9248f86c/software/TMC5160.ino
Which says its requires this library. I install…
-
### Bug Description
I have tried to verify this bug by printing flat circle. It fails.
Instead of printing circle as curve it is being printed as short lines and extruder producing too much noise.
…
-
Bonjour à tous,
Sorry in advance if you consider this as a “support” question but I don’t feel it is.
I'm trying to set-up a printer SKRv1.3-based with sensorless homing feature, using TMC5160 on X …
Patag updated
4 years ago
-
### Description
Unable to compile Marling bugfix 2.0 with TMC5160 drivers on RUMBA32 board
### Steps to Reproduce
**Required:** Please include a ZIP file containing your `Configuration.h` and `…
-
Error occurs when stm32f4 chip uses IDEX mirrored mode.
AUTO_PARK OK
DUPLICATION OK
T1 printing alone is OK
Using IDEX mirror mode T1 will vibrate and not move left or right.T0 OK
Lp…
-
I have replaced my Z Lead screws from ones with 8mm lead to 1.5mm lead. I did adjust steps/mm and did some test cube prints. Print was perfect. However as my lead distance shortened my Z-speed dropped…