-
```
Running the example in the library I get the error: 'CAN' was not declared in
this scope. I installed the library by copying it in the Arduino/libraries
folder. Am I missing some required librar…
-
I am running the gettingStarted samples with "+" radios from sparkfun, on Arduino Uno. I use pins 7 and 8 in ordr not to interfere with 10 and 4 which are used for the shield. With only the board eve…
-
Hello:
I used Arduino UNO with USB Host Shield, and they can work, but I found USB Host Shield SS pin is high.
In MAX3421E data sheet, if SS pin is low, then SPI data can transmit.
As far as I und…
-
Hello,
Using Arduino 1.8.3 IDE, the latest version of your repo and the 1.3.0 version of the USB host shield library, even though the code compiles fine, there is no activity on the MFD of the joys…
-
# problem:
after i connected my usb host shield with my arduino uno and i ran the sketch for PS4USB i see in the serial monitor
`OSC did not start`
and the controller doesn't even connect because i…
-
```
- Car is Alfa Romeo Giulietta 2010 1.4 MA
- OS: win 7 SP1 x32
- can shield is with MCP2516 and is working with Arduino Uno r3.
- Arduino and Can shield is working on car
-Sniffer car ECU --------…
-
Hey I am currently working on a tracking device with LiPo battery and BLE, I fount that if the device is not booted using the USB connected as serial port the GPS shield attacked to a Arduino MKR 1010…
-
# A prototype PCB is needed to develop the firmware
The prototype pcb should have all experimental features attached to an arduino-like pcb ("shield") for arduino uno
-
hello,
I have 2 module LoRa Radio Shield for Arduino - 900 / 915 MHz. but i haven't gateway. and i want connect them by p2p mode. but I not found a example about that. can you help me that problem?
-
```
What steps will reproduce the problem?
Method A:
1. Open the root of an SD card
root = SD.open("/");
2. List the files with the example code
printDirectory(root,0);
2A. All files on card show up.…