-
Sanguinololu, Gen7, OpenHardware.co.za controllers etc - several machines use the Gen7 bootloader on a ATmega 1284p
When trying to flash Hex using Cura it fails with unrecognised signature:
Protocol:…
ghost updated
10 years ago
-
Hello and, first of all, thanks for this library :-)
I'm trying to get it work with an ATMega644 chip
I've changed Enc28J60Network.h file in this way, according to 644's pin
# if defined(**AVR_ATmeg…
-
Hi repetier!
It would be great if ATMega1284 support could be added in pins.h for GEN7 boards.
# if !defined(**AVR_ATmega644P**) && !defined(**AVR_ATmega644**) && !defined(**AVR_ATmega1284**) && !def…
-
Sorry, gerade erst gesehen. Die gleiche Problematik wie beim ATmega1284 mit der Analog-Reference.
Auch hier sollte der AREF-Pin nur über einen Kondensator an AGND gelegt und nicht an AVCC angeschlosse…
Udo1 updated
12 years ago
-
This is really odd. This same project runs cmake just fine on a Linux box, but, on my Mac fails. What is odd is that the stated failure is that an unsupported board was specified, but, that same boar…
-
Firmware: kliment-Sprinter-52f7f30 Ver1.3.11T
Software: PronterFace(Sorry, I don't know the version)
Hardware: Sanguinololu V1.3a
MCU: Mega644P
printer: Mendel
Sprinter configuration: Size= 170_16…
-
Das Flashen via AVRDUDE funktioniert nicht. Das hex-file scheint nicht korrekt formatiert zu sein. Darüber hinaus ist die ID des AVR seltsam, siehe unten:
avrdude: Device signature = 0x1e9706
avrdude…