-
Good day !
I ask for help in solving the problem !!!
My kit : SCR Pro v1. 1 & TMC5160 x 6 & Motor 24V 1.8 deg 2.0 A x 5 & Motor 24V 1.8 deg 1.5 A & Motor 24V 1.8 deg 3.0 A & Marlin 2.0 !
My task…
-
Hello, I am using the following Bluetooth 5.3 USB dongle on my M8P + CB2:
https://www.amazon.com/gp/product/B0BL3BTVFJ
It didn't work out of the box for the CB1, requiring that rtl8761bu_fw.bin be…
CMahk updated
2 months ago
-
Hey there,
the blue LED from the U2C V2.1 is always on, but the board is never in DFU mode. Tested with RPI and Windwos with "STM Cube Programmer".
Any ideas?
-
#### Issue:
When Configuring of Dual Z endstop in SKR2 board the `Z2_min` fails to get mapped to `XMAX `or `YMAX` pins.
#### Steps to reproduce:
* Download the latest Marlin2.x release from m…
-
Hello all,
I am using the latest version, v2.2.1. I flashed a fat32 formatted SD card with the file. Ejected it, plugged it back in, edited the system.cfg file with my wifi ssid and password, saved…
-
The Z-stop optical sensor that ships on the CR-6 SE is rated for 5v-24v. I have confirmed that the sensor that shipped on my CR-6 SE won't operate below 4v. The voltage on the Z-stop port of the BTT…
-
As it is this will not work with an Artillery Sidewinder X1 or any other printer with a 250000 baud rate. This really needs to be a configuration option at install.
To fix:
change:
mainwindow.c…
-
Hello everyone!
I have a big issue with SKR 2 and BTT TMC2226. Im setting up Marlin for 2209 with UART, putting jumper in places like in manual, but having TMC Connection error. Also in standalone …
-
I have installed sunxi-tools on ubuntu and when I try to run sunxi-fel-aarch64 I get : ./sunxi-fel-aarch64: 2: Syntax error: "(" unexpected.
I have tried downloading everything a few times and it doe…
-
will this work on biqu b1 or artillery sidewinder if i compile the firmware?