-
Current firmware needs to be the non 512kb. The current chip for the SKR mini E3 v1.2 RCT6 only has 256kb
https://www.st.com/en/microcontrollers-microprocessors/stm32f103.html
-
MTMR seems to be a very nice alternative to BTT, but they have one common issue: cpu usage. I have a very simple config with a couple of currency rates, weather and some basic controls (volume, bright…
-
This is a big issue and it can be done in different ways, from a really simple solution (no verification, pay hosts once a day) to a really complex solution (lightning, streaming payments, etc).
On…
-
The Z-stop optical sensor that ships on the CR-6 SE is rated for 5v-24v. I have confirmed that the sensor that shipped on my CR-6 SE won't operate below 4v. The voltage on the Z-stop port of the BTT…
-
Please consider Disable Linear Advance by default in firmware as per @morningreis guide with tweak for SKR E3 Mini v1.2:
- https://www.reddit.com/r/ender3/comments/dojh3v/guide_for_those_upgrading_…
Hedda updated
4 years ago
-
There are no gestures and the proposed "gestures" like holding one finger and taping the other are unnatural and impractical.
-
Hi, I recently bought a bl touch 3.1 and installed it it came up with the m999 error and wasn't sure why. I tried rerouting the wires but it didn't work. Thank you if you have a solution.
-
Hi Guys ,
I know its a bit strange but i tried to flash Btt tft 35 firmware to mks tft 35 bcz its open source but my screen has gone black and now i am not even able to flash mks firmware to it i che…
-
### Description
Turn on device and I get fade height error , and many other errors followed by a continue click of the knob without touching it I have SKR mini e3 v2.0 and TFT35 v3.0
### Steps …
-
I was able to download the schematic for my SKR Mini E3 V2, and assumed I'd find one for this board as well. Where is it?