-
I just cloned the project and tried to compile it using ESP IDF 4.3.6.
All is well,but grblHAL_AP can't be found,I don't know what I did wrong.
This is my_machine.h.
Thanks for your help!
/*
…
-
Can DMA be used?
-
When using an older machines.xml (ie. not one of the new "The Replicator" machine definitions but one such as "Cupcake Basic") a NullPointer exception is thrown.
Console:
INFO: Estimating...
Exceptio…
-
Hey guys have it all wired up, still waiting on power supply to test. just checking if this looks correct.
I've noticed that my drive seems to be like a mix between the two examples shown on the wi…
-
According to @KoshiroRobot ([YT video](https://youtu.be/KnYSuQEBGHc?t=583)), the 60 fps of the camera seems to be the limiting factor for a ball bouncing controller.
I like this project and I'm thi…
-
Currently, it's only possible to adjust the extruder steps/mm via de LCD menus, not the extruder direction.
However, many printers are shipped with very simple extruder designs, these are often tri…
-
Hello,
Is there pcb for esp32 to working with external drivers using X,Y,A,B pins added in the last firmware (x6 defined in cpumap)? If right, where we can buy it for own project.
Thank you for you…
-
where can i find firmware.hex?
or do i have to make it my self in platformIO?
Marlin display say "update mmu firmware" or do i somthing wrong? i folow the youtube of Chris Riley
thanks
-
Hello
I try to run two stepper motor drivers at the same time.
Since synchronicity is important to me, I tried to run two wave chains at the same time, but when the second chain starts, the first ch…
-
Hi,
I get under Marlin 2 no UART connection to the TMC2208 drivers.
The jumpers on the board are set correctly.
The TMC2208 version 3 should not require solder bridges either.
Various settings in …