-
I am having difficulty flashing the MCU of the manta M4P. I have tried the following
- compiling klipper myself and using SD card slot (full size SD card)
- used the precompiled bin file on the gith…
-
will this work on biqu b1 or artillery sidewinder if i compile the firmware?
-
Hi, attached the result of M122 command in
Pronterface:
-
even 4bpp would be enough.
Ststistic:
* 24Bpp take 4.5Mb
* 8bpp take 1Mb and will be 3.5Mb free instead
* 4bpp - 700K - 3.8Mb free
smaller footprint of media gives more space for extended funct…
-
I can control the mixer settings in marlin mode but I dont see anything in touchscreen mode. Is there any way to enable this??
-
I am trying to compile Marlin-bugfix-2.0 for a Bigtreetech SKR PRO V1.1 that uses the New LiquidCrystal Library and I am able to get a successfully compile but I get WARNINGS from the LiquidCrystal ro…
-
The board have 4 x TMC5610 drivers attached to it, the main board is communicating to computer normally all working fine(Stealth chop, end stops, heaters, sensors, I tried troubleshooting the connecti…
-
This ist not a Bug. More a question.
Which bootloader the skr3 ist using? Where i can find it?
I mean the custom bootloader Not the one from stm.
Thank you 👌
-
### Description
Starting Cura crashes Printer
### Steps to reproduce
1. [First Step]
Connected with USB
2. [Second Step]
open Cura 4.8
3. [and so on...]
rebootloop till unconnect or clos…
-
Hello,
After a lot of struggle, I got Klipper up and running, but none of the fans are working.
I have FAN0 (cooling parts) and FAN1 (heatsink) connected, and also FAN6 for controller-board cool…