-
Dear BTT team,
Can you please also upload a klipper config for the EZ variant (I saw some differences in the schematics)?
I want to make sure I've set my config right.
Also, I'm working on getting …
-
Now that Apple has removed Python from the macOS 12.3 betas, it might make sense to switch the templates to use Java Script widgets - so no third party binaries are needed.
I'm opening this issue …
-
Dear bitcoin forkers,
Thank you for this great script! I have successfully clamied the following coins.
BCX, BCI, BCD, B2X, BTW, LBTC, FBTC, BTP, SBTC, BIFI, BTV
However, I am struggling with…
-
http://www.anzhuoshouzhuan.com/app/107.html
-
recently installed my 1.2 board and after a lot of troubleshooting got it to the point where at least the marlin model would work but still cannot get it to work on the btt mode. made sure the rs232 c…
-
I have tried all the solutions that I have read .. and none have worked
https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3
It always turns out the same mistake.
**STM32F103RC_btt_512K …
-
Hi !
I have a 3D printer with dual extruder and a 2 nozzle hot-end.
I am using BigTree Tech SKR PRO V1.2 mother Board and BTT TFT 3.5.
I am printing with 2 nozzles perfectly fine.
I thought of con…
-
I tried to make a setting in Marlin 2.0 bugfix so that I can describe the epromm and then I loaded the Firmware.bin. Because I could not set a command M500 Now I can no longer load firmware via SD car…
-
On Fedora 35, two warning messages are returned. These are harmless, but should be resolved.
```
# meson setup build
The Meson build system
Version: 0.59.4
Source dir: /downloads/ndctl
Build d…
-
not sure how to do the pull request stuff but I had to modify the pins_BTT_SKR_PRO_v1_1.h with this to get the display to work - added just below ULTIPANEL entry:
#if ENABLED(MKS_MINI_12864)
…