-
hello, I am trying to communicate this type of ebyte e32 modules with ttgo lora esp 32, but it has not been possible to change the addresses, the frequency set them to 915 mhz and I have not yet been…
-
Are there any possibility to get RSSI value, something compareable or any means to monitor signal/communication quality/strength for the E32868T30D?
I guess the module itself does not provide that? D…
-
@grobasoz OK to request or suggest that release precompiled EmberZNet 6.8 NCP application firmware as optional downloads?
Silicon Labs EmberZNet SDK version 6.8.0 (6.8.0.2) was released this summer…
Hedda updated
3 years ago
-
Hello,
I'm using EByte nRF52840 module with DS18B20 connected in normal mode (VCC to +, GND to - and DQ to nRF pin 26). When nRF52840 starts, consumption is so low that my tester with 0.00000A reso…
-
I have a sx1280 from ebyte and im wondering if i actually need to use the TX_EN and RX_EN pins as other moduls dont have them. Also in a circuit diagram the DIO pins 1 to 3 arent connected to the MCU.…
-
I just bought an E800-DTU (Z2530-485-27) from E-Byte for 160 CNY (~25 USD). As what the model number implies, it is based on the E18 ZigBee module (also from E-Byte), which has an CC2530, communicate …
-
Mysterious black box..whats inside?
So I monitor mine with an AM radio nearby, you can hear the morse-code like speed of the communication of these units, im thinking mine are at about 50b with mai…
-
I have a CC2531 connected to my server. I found that, even using the provided external antenna, the reach is not enough and I would like to relocate the device.
I have another spot very suitable, …
-
I stumbled across this beastie whilst looking for alternatives to CC2231
https://www.aliexpress.com/item/4000060995530.html
It appears to be a CC2530+CC2591 with integrated USB interface and I'…
-
I get the following output when calling Transceiver.PrintParameters();
```
----------------------------------------
Model no.: 0
Version : 0
Features : 0
Mode (HEX/DEC/BIN): 0/0/0
AddH (HE…