-
Hello,
ESP-RFID will be better if we add a buzzer attached to an GPIO and send short sound signals, on reading, giving access/deny access , powerup, ЕТC. I can offer my help for that. I got some (abo…
-
My Setup:
NodeMCU V3 / LoLin 0.1
RFID-RC522
My Pin Setup
D1 -> GPIO5 -> SPI SDA
D2 -> GPIO4 -> Relay
D7-> GPIO 13 -> SPI MOSI
D6 -> GPIO 12 -> SPI MISO
D5 -> GPIO14 -> SPI SCK
I try t…
-
Hello together
Thanks for developing that wonderful software. Unfortunately I cannot change any settings as the following is sent over the serial connection:
> [ WARN ] Failed to open config fil…
-
I try to compile otb-iot on a freshely set up Virtual machine with open-sdk (latest)
after correcting some conflicting declarations in esp_systemapi.h (commented as they seem to be already declared i…
-
Thank you for your project When I give the NodeMCU brush into the firmware, log on 192.168.4.1, in the interface after the operation click the save button is not used, the serial monitor will keep the…
-
I've read issues #99 and #98 , which both related to 0.7.
I've been trying to sort this out, and found out the NodeMCU chip only enters in the infinite loop when I change the hardware settings to M…
-
I've got this joining my wifi and initialising the MFRC522 — so far so good.
I'm stalled now on the web UI with it saying "Please wait while fetching data..." — which it never does.
I've tried r…
-
Hi!
I'm returning to your great project again.
I previously worked with it at a time when it was not a PlatformIO project.
I have zero experience with PlatformIO and it is very difficult to jump in…
Pako2 updated
5 years ago
-
How could MQTT be used? Is there an example?
Thank you
(I do not speak English)
-
Is it possible to use one more pin for a button which will trigger the relay to open a door from inside?