-
Currently the "idiomatic" Zinc method for accessing registers is through the use of the ioreg macros to create a new type mapping the hardware register layout. Then those structs are mapped at the cor…
-
Compilation of a sketch for C2k board crashes because the path for --preproc_dependency is incorrectly inferred from current path. Compilation for msp430 or Tiva/Stellaris board competes successfully.…
-
![smokymtsci](https://cloud.githubusercontent.com/assets/7808557/4064529/5aaf3d7e-2e12-11e4-9d65-69196c4794ad.png)
@jywarren @mathewlippincott
-
Ok so i'm doing some testing with my hardware and I've been experiencing some barf of Grbl when I perform lots of small linear motions with higher accel decel rates. I have 120=600 110=1800
With the…
-
Changing the board type selection from EX-TM4C1294XL to the EX-TM4C123GXL the FPU clock speed define remains set at 120 Mhz. I can work around this minor bug by requesting a serial baud rate 50% highe…
-
Motor PWM peripheral is clocked at the same frequency as the Servo PWM peripheral.
Unfortunately, the PWM Capture Compare and Reload registers are only 16 bits wide, which means that a motor freq of …
cmonr updated
10 years ago
-
This is a followup for a discussion here: http://forum.stellarisiti.com/topic/1904-pinmode-and-digitalwrite-outside-setup-and-loop/
The long and short of it is, in general, nobody writing Arduino or …
-
We created an object that has a constructor that calls micros() and we observe that the program hang there.
This is the code for the object:
```
// -------------------------------------------------
…
-
Are you considering other platforms?
The [LaunchPads from Texas Instruments](http://www.ti.com/ww/en/launchpad/launchpad.html?DCMP=mcu-launchpad&HQS=launchpad) are powerful and affordable, with an A…
-
From http://github.com/energia/Energia/issues/336
The I²C specifications ([NXP](http://www.nxp.com/documents/other/UM10204_v5.pdf), [I²C-bus.org](http://www.i2c-bus.org/clock-stretching/)) allow the …