-
### Description
Have an advanced probe offset wizard that also gets x and y
### Feature Workflow
1. Tape a paper with drawn crosshair to your bed.
2. Manually Move probe over crosshaircross…
KUGA2 updated
3 years ago
-
Ok, so first a disclaimer; I'm not very well-versed in Schematron... We are kind of forced to use it as we run Peppol (peppol.eu) and we have a Java implementation based upon [ph-schematron](https://g…
-
### Did you test the latest release build?
No, but I will try it!
### Bug Description
I had a go at installing Klipper and couldn't get it to work so I'm back for good !! I hope you guys keep going…
-
Newbie question, any reason why C# and .NET is not supported? Would it be possible technically?
Apologies in advance if this is out of scope of the project.
Thanks
-
I made a post in the main branch of [Marlin](https://github.com/MarlinFirmware/Marlin/issues/22996) & another user [here](https://github.com/bigtreetech/SKR-2/issues/96) has a similar issue.
What I…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
when using SW Mode & HS mode, I am getting errors /failures probing every other point
…
-
### Did you test the latest release build?
Yes, and the problem still exists.
### Bug Description
December Rev 1 release. It appears that for the ProUI UBL version, the Mesh Fade now defaults to 2,…
vw72 updated
3 months ago
-
I just recently got the SKR V1.3 for the wiring simplicity and 32 bit stuff. Sadly, this has also created a few issues. The SPI jumpers are in the correct places and the +5V is in INT like it is suppo…
-
So I just recently installed a BIQU MicroProbe V2
Double checked that pins match with that on board
Followed directions from instructions provided
Previously, I did have a BL touch that worked fine…
-
Hey there, is this repo still being maintained? I notice it still lacks the following extension and component signatures:
http://www.datypic.com/sc/ubl21/s-UBL-CommonExtensionComponents-2.1.xsd.html
…