-
```
Summary: when calling analogWrite() with values 0 or 255, it defaults to
analogWrite() which leaves PWM registers in the previous state, and the next
analogWrite() starts with a "glitch", very n…
-
```
Summary: when calling analogWrite() with values 0 or 255, it defaults to
analogWrite() which leaves PWM registers in the previous state, and the next
analogWrite() starts with a "glitch", very n…
-
I designed a PCB for this great project, ordered with JLCPCB ($2 for 5 pieces, and $2 for shipping).
The PCB is only compatible for a quadcopter with wire for INAV 7.1.
The wiring diagram is in sect…
-
```
the current core definitions are huge walls of code with ifdefs sprinkled in
between: very hard to follow.
I actually did this already, though I only tested that the "Fade" example
sketch compi…
-
```
the current core definitions are huge walls of code with ifdefs sprinkled in
between: very hard to follow.
I actually did this already, though I only tested that the "Fade" example
sketch compi…
-
```
the current core definitions are huge walls of code with ifdefs sprinkled in
between: very hard to follow.
I actually did this already, though I only tested that the "Fade" example
sketch compi…
-
```
the current core definitions are huge walls of code with ifdefs sprinkled in
between: very hard to follow.
I actually did this already, though I only tested that the "Fade" example
sketch compi…
-
Is it possible to have EXRAIL send out an I2C command to a slave device? Not the Ex-ioexpander.
Why?
I created an attiny85 with an L293D motor driver chip to control two Kato turnouts. I plan t…
-
Me again. I noticed that the Gigatron microcomputer got promoted to working in 0.224, which is pretty cool. However, there's currently no way to input anything from the keyboard, which makes it imposs…
-
Hello I have multiple attiny85 all on the same i2c lines as slaves each with a unique address. However there seems to be an error where the i2c line appears to keep hitting the reset condition if they…