-
### What happened
The wifi hotspot should be stable, but something (probably nmcli) is conflicting and causing it to crash. If you remove nmcli then ethernet doesn't work.
### What did you expect to…
-
I believe that I have all the config.h files modified for my Ender 3 Pro. I will be running the BTT SKR Mini E3/V2 board. I have dual axis Z steppers, and a much bigger than stock build volume. I have…
-
Hi. I have a working custom RPI CM4 board. CB1 module (v2.2) after power on eats 120ma from 5V bus and it looks like it can't start. RX/TX shows nothing, hdmi/ethernet nothing. I tried to set usb boot…
-
Got ff vs e5 as always. The board doesn't recognize the accel chip no matter what.
Tried uncomment the spidev0.0 then specify in config, and it's not a wiring problem because it worked on my M8P V1.0…
-
Hi all,
my SKR V1.4 suddenly don't load frimware from TF card, is possible to load it via USB with Xloader or Ultimaker Cura? or how can i reset completely the board?
-
Hi,
I've just purchased the SKR 1.4 Turbo & TMC 2209 for my CR-10S printer and have a few simple questions.
A:- Do I set it up for UART mode, if so do I leave all the black jumpers on or not
…
-
Hello.
I'm hoping you'll eventually release the source files of the firmware so the community can modify it to suit whatever upgrades we may install on this printer. Currently, I only see pre-compi…
-
# GUIDE:
1. You CAN NOT mix PT100/PT1000 and thermocouples:
If you have only one hotend then you can have the following:
- Thermistor (that is an ADC Temp Sensor [uses a pure analog I/O pin]…
-
You have this:
![image](https://user-images.githubusercontent.com/122113075/232467694-43bceb4d-a954-4b92-8f30-5fd8b92d2733.png)
Where is the Marlin image???
How to I flash Marlin, when Klipper is i…
-
Is the SO3 tool board compatible with BTT BIQU Microprobe?
I have a 3D Touch (BL Touch knockoff) connect and working. I am trying to replace with the BIQU Microprobe (v2). I added the Klipper code …