-
Hi, @tingox! After you opened issue #1, I got curious to learn more about the methods you're using to read paper tapes. And also which projects are you interested in / working on that use paper tapes.…
-
Hello,
First of all, I'd like to explain that I was just making some tests with Teacup, my first option was Marlin, and actually the issue I'm about to say it doesn't happen in Marlin...
I'm worki…
-
Hi Omuzychko ! Thank you for your contribution !
So i've been trying to make my motors work on an STM32F4 Discovery Board with 2 Bipolar Steppers and DRV8825 drivers, didn't work for me !
Motors are…
-
Currently hybrid threshold can only be set with a max speed, but speed doesn't require more torque from the motors, its high acceleration and jerk that need it.
I found that my printer could lose …
-
I have S109 drivers based on TB67S109AFTG. They need vcc=5V.
May I set VLOG JP101 to 3-2, (FD_5V) with Due ?
-
Hello
I try to run two stepper motor drivers at the same time.
Since synchronicity is important to me, I tried to run two wave chains at the same time, but when the second chain starts, the first ch…
-
I have a 6 pack controller that I have gone over the wiring multiple times. Had a friend also look at it. to confirm. I seem to have everything hooked up correctly. I can Enable and disable the moto…
-
Hi
Just updated firmware using the configuration tool. I use singlenozzle configuration with 2 extruders on prusa-like printer.
STRANGE PROBLEM: **Every time Z is moving the Extruder 2 is moving too…
-
Hello, I will be using a teensy 4.1 and 2 TMC2209 V1.3s wired directly without a shield.
For the 2209 V1.3, is spreadcycle the default mode? If not, how do I switch it?
If I just have to us…
-
Printer: Creality CR20
Board: SKR 1.4 Turbo (BigTreeTech)
Driver: TMC2209 (BigTreeTech)
Driver Config: UART
### **Error:**
`M112`
```
Recv: Driver registers:
Recv: X 0x00:00:00:00 Bad r…