-
Using the latest bugfix 2 in Atom/platformio with TMC2208's using software serials getting ..
"**error: 'X_SLAVE_ADDRESS' was not declared in this scope**"
error (and Y_SLAVE etc) s showing up w…
-
### Description
With `PS_DEFAULT_OFF` disabled my Re-Arm board will never successfully boot to the boot screen.
### Steps to Reproduce
Comment out `#define PS_DEFAULT_OFF`, reset board
**…
-
### Description
It seems that if you try to enable PINS_DEBUGGING and Z_DUAL_STEPPER_DRIVERS (I haven't checked for X and Y, or triple Z) at the same time, the firmware won't compile due to the…
-
Just wondering if these boards are suitable for grbl-lpc since they also use the lpc1768 mcu at 100 / 120mhz but cost less than the models found in the releases tab.
Also it has the ability to use s…
-
### Bug Description
After doing a G28 for homing all axes all end switches are triggered and position is reported as 0, 0, 0.
When travelling in either X or Y direction the z-axis moves down 5…
-
SKR 1.3 TMC5160s V1.0
since updating MCStepper V0.4.0 I no longer have access to my serial port
[Configuration.txt](https://github.com/MarlinFirmware/Marlin/files/3269833/Configuration.txt)
[Co…
-
I git pulled the latest 2.0 and after G28 on my delta, the Z height is set to 1mm instead of the delta height.
### Steps to Reproduce
1. Pull latest marlin
2. Send G28
[Configuration.zip](…
-
MKS Gen L board w/ TMC2130 drivers in SPI w/ diag pins of X and Y wired to the respective min endstops. Had to enable software SPI to keep the single ribbon to the Ender 3 LCD. I've adjusted M914 for …
-
![IMG_0987 — копия](https://user-images.githubusercontent.com/47144059/76435262-d4ea7b80-63c7-11ea-815c-9816a3bfc6c1.JPG)
Hello,i have one problem. I install SKR 1.3 + TMC5160 v1.2 instead of MKS_G…
-
### **Bad Auto Tune and useless PWM/PID stability**
I have taken the time to perform extended testing and gather an excessive amount of data tracing this issue back to just after Marlin Official …