-
RaspberryPi Zero Wを連続使用中にランダムでStackTraceを出力し、ネットワークでの通信ができなくなる。
以下、再起動後に取得した `kern.log` の内容
```
Jan 18 05:01:49 raspberrypi kernel: [2528523.510012] ------------[ cut here ]------------
Jan 18 0…
-
I got this "TP-Link Archer T3U" and it's identified as following device:
Bus 001 Device 004: ID 2357:011f TP-Link 802.11ac WLAN Adapter
dmesg output after modprobe -r 88x2bu and modprobe 88x2bu:…
-
It looks like some users are having troubles bringing custom firmware blobs to their nodes, mostly because the default location under `/usr/lib/firmware` is read-only.
The proper way to do that wou…
lucab updated
3 years ago
-
When compiling 5.4.51 natively on an RPi4 using bcm2711_defconfig with gcc-10.1.0 and glibc-2.31, cfg80211 fails to load regulatory.db - there are no errors or relevant warnings during the compilation…
-
Here is the output of dmesg. I am having 6 usb wireless adapter using 8852au drivers on a usb hub connected to my raspberry pi 4B, this warning appeared when i plugin my usb hub. Is it a problem which…
-
Hi @mirobiala
I have a rtl8852cu device that I'd like to create kernel module for.
so far, all of my tries were unsuccessful.
I'm trying to build for the latest x86 snapshot (so kernel 6.1 until 6…
ntzb updated
5 months ago
-
There is a problem with the firmware in Bookworm for the wifi-chip on Zero2w. It is a known problem for many users, and it has been discussed in the raspberry pi forum: https://forums.raspberrypi.com/…
-
I Was fighting weeks with unreliable 2.4 Wifi connection on PI4 4GB. 5Ghz never really worked, till day I switched from network-manager to manual wpa_supplicant.conf use. I believe this is related to …
luzik updated
3 years ago
-
Hi, I'm new to Linux.
I successfully build this driver but can't get the 8188eu.ko to work.
sudo insmod 8188eu.ko
... says ...
insmod: ERROR: could not insert module 8188eu.ko: Invalid parame…
-
I have a Realtek rtl8188ce and Ubuntu 13.10 with kernel version 3.11
"06:00.0 Network controller: Realtek Semiconductor Co., Ltd. RTL8188CE 802.11b/g/n WiFi Adapter (rev 01)"
I followed all the instr…