-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
There is a one-off error that is allowing writes to location 0x200. The address writable should be 0x1FF.
```
0x000 00 01 02 03 04 05 06 07 08 09 0A 0B 0C 0D 0E 0F
0x010 10 11 12 13 14 15 16 17…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
```
What steps will reproduce the problem?
1. No overlay at all
2. video is ok from GoPro
3.
What is the expected output? What do you see instead?
I am only getting video from OSD. No overlay whatso…
-
_From @koenkooi on February 12, 2012 18:17_
I noticed some garbage data in the pinmux section of the cape I flashed with bonescript. It went away by doing cat /dev/zero > /sys/bus/i2c/blah/eeprom bef…
-
The implementation of eeprom_init is unreasonable in https://github.com/deadsy/grbl_stm32f4/blob/a70dfca1467828aa3ed2150312247c298f79b76a/grbl/files/eeprom.c#L21
Here, the purpose of this operation i…
-
Looks like the Brawler 64 Wireless on N64 isn't responding with data. Looks to be detected though. There are notes in Raphnet v3 about it specifically. They set a delay between 0x00/init/capabilities …
-
## Arduino 1.8.19 esp32 SDK2.03
- Chip used: [ESP32C3|none]
- SDK 2.03(run ``git describe --tags`` to find it):
-
EEPROM.begin(2048)
EEPROM.writeInt(1,val);
EEPROM.commit();
…
-
I would like to request the addition of a writable EEPROM element with the capability to store data persistently. It should allow the information to be readable even after the software is closed.