-
M600 NOT WORKING
**Fully working on old releases but not the last 1.1.5 and current bugfix**
The first retract have a bug ' retract and immediatly recover'
The loading is two or three times the loa…
ghost updated
3 years ago
-
Hello!
I have came across this behavior while experimenting with your latest version.
Path and face:
The path starts at the upper right position in the first quadrant and ends at the origin (…
-
I recently had an idea of mounting the extruder motor on the x gantry of a Prusa style machine rather than on the frame (bowden) or x carriage (direct drive). A looped belt would run across to the ot…
-
Deprecated, see comment 5:
Dear Marlin developers,
I'm sorry to bother you with my problems but there might be an issue with the current Marlin release. The problem might also sit in front of the …
-
### Version
Version 2.3.0+linux-x64
### Operating system type + version
KUbuntu 19.10
### 3D printer brand / version + firmware version (if known)
It doesn't matter. The problem in the slicer…
-
Hi - Still working on getting the BugFix version to work. Downloaded a new RCBugFix branch today and am getting an issue with the ABL functionality. The probing starts in the center (X0 Y0) and moves…
-
Hello again!
This time extrusion stops in the middle.
Not sure if this is helpful, but these are the vertex positions. There are 11 vertices in total.
0: 25.98, 15.00, 0.00
1: 13.54, 1…
-
Hey,
So I was running the TMC5160 over SPI on a SKR v1.3 for quite some time without any issue.
Due to a heatbed upgrade I moved to a 24v PSU and problems started.
Using the exact same klipper…
-
I have a model that does not slice properly if particular settings were applied. I did not identify what settings exactly influence it, but I am attaching a working and a non working .ini
This happ…
-
### Bug Description
my bltouch v3.1 is probing but my first layer not even near being level, i have pre leveled the bed manually.
i've checked my axis steps but even after adjusting them,it's not …
ase95 updated
3 years ago