-
# What is the main application for your prototype?
-
```
Starting system: Greenhouse
Init shift
Beep set shift
Beep clear shift
[1499] Connecting to Manhattan
[5734] Connected to WiFi
[5734] IP: 192.168.1.191
[5734]
___ __ __
…
-
### PROBLEM DESCRIPTION
Two SONOFF MS01 sensors don't work in Tasmota32 12.0.2.3
1. I connect two sensors to ESP32 board to GPIO 2 and GPIO 4. MS01_4 = valid result. MS01_2 = null.
2. I recon…
-
Please use the template and fill in all the data requested below!
**Problem description**
Way to get soil_moisture readings to Homekit
**Suggested solution**
Convert soil_moisture reading as a…
-
The old version used some components that were not compatible with 3.3v logic/voltage, such as the L293D to control the motors.
A new design is needed that can be used with 3.3v, and potentially also…
-
Currently the PID control system outputs the time periods for which the pump should be on or off, and manages this by itself.
This won't work with our asynchronous design of the system, so I suggest…
-
Hello,
I'm interfacing with a TEROS 12 Soil Moisture Sensor, and whenever I activate the watchdog in my SAMD21 processor (based on Feather M0), the system hangs on reading data (with 8s timer).
…
-
One of my test setups using a BMP280 sensor had stopped communicating with the sensor, so I was looking into the code for this sensor and I noticed there was a lot of "standard" code in there for basi…
TD-er updated
2 years ago
-
**Item's use**
SDI-12 is the communication protocol that is used by the Teros and Decagon sensors.
**Product Page**
[Teros 11/12 Integrator Guide](http://manuals.decagon.com/Integrator%20Guide/1…
-
Thanks again for the great work on this library.
I have a device that transmits with the following settings :
https://github.com/Makerfabs/Lora-Soil-Moisture-Sensor/tree/master/V3/firmware/Moistur…