-
**Application version**
4.2.1
**Platform**
I use MacOS, but I'm sure this applies to all OS'
**Printer**
Creality3D Ender 3
**Reproduction steps**
Add printer, go to machine settings, loo…
-
I have just succeeded in compiling the new firmware in VSCode/PIO for my BTT E3 Mini V1.2 thanks to Morningreis on reddit.
https://www.reddit.com/r/ender3/comments/dojh3v/guide_for_those_upgrading_…
-
Is anybody else seeing layer shifts on BugFix 2.0.0 ? I'm seeing one or two of them on long prints. I'm seeing them on the X-Axis (and mostly in the negative X direction).
I'm running an IDEX m…
-
Workaround(s):
1.) Try latest code https://github.com/MarlinFirmware/Marlin/issues/15767#issuecomment-552228142
>
> #### NO NEED to downgrade to PlatformIO Core 4.0.3
>
> 1. Use the latest…
-
The bed is heating and it seems to be reading a temperature increase.
But after a while the system halts with a "thermal runwaway" error message.
Also the heating bed connector at the rear of …
-
EDIT: This thread has been very helpful. There is definitely a hardware problem here and Creality has been SUPER slow about and "round about" in regards to providing help. Long story short: When m…
-
My BLTouch works perfectly and deploys and retracts on command but during g28 it will not deploy
/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinF…
-
Hi.
After updating to the firmware in this repo I am no longer able to connect to the printer over Serial using baud rate 115200. Luckily I can still re-flash and I have re-flashed to make sure it …
-
Please give any feedback on the board design (schematic and PCB) on this thread.
-
This is an enhancement on the FFC version boards that will introduce a replacement for the housing on the x-axis motor on Creality style gantries.
This housing typically holds the x-min endstop in …