-
PIO Core Call Error: "The current working directory C:\\Users\\Vincent\\Documents\\PlatformIO\\Projects\\Lora sender will be used for the project.\r\n\r\nThe next files/directories have been created i…
-
One small issue generated by recent pull request #18. It seems to have broken my ability to link using platformio when I have a copy of LoRaLayer2 in my `lib` directory, but I am building using the co…
-
When flashing 1.4.4 the device stays in a boot-loop. As i understand the log, it has to do with initializing the non-existent psram
````
Rebooting...
ets Jun 8 2016 00:22:57
rst:0xc (SW_CPU_…
-
Hi,
I've just attempted a compile of the code and hit the following error:
Using library U8g2 at version 2.27.6 in folder: C:\Users\David\Documents\Arduino\libraries\U8g2
exit status 1
…
-
Please - if you just have a question (i.e. not a bug report or a feature proposal), post in our [forum](https://meshtastic.discourse.group/) instead.
**Describe the bug**
The spec says that the ra…
-
HI,
Where can i find setup for SX1276 chip example because we have only for RFM95W chip ?
Thank
Eric
-
I wanted to use a LoRa Radio Node board with an 328 chip and OTA on the V3 stack. It uses the old LMIC library and joins, but does not transfer messages. Serial stops after:
LMIC-node
Device-id…
-
Hi!
I'm trying to connect a BME280 to a TTGO Lora32 V2.1 NEW but I can't get it to work.
I connected the sensor and changed the section in generic.h to:
```
// BME680 sensor on I2C bus
// #…
-
**Describe the feature request**
I have a couple of Heltec units without GPS that I would like to report from a static, hardcoded position. These will be fixed relay nodes with no use for a GPS, whic…
-
Arduino version 1.8.13
arduino-lmic v3.3
TTGO T-Beam V1.0
Board ttgo LoRa32 OLED-v1
Upload speed: 921600
Flash freq: 40Mhz
Core debug level: None
I tried to use the lmic v3.3 library, with th…